This setup will successfully take you through the roughest terrain. Your trailer will need to be pretty tough to handle this setup.
- 1 X 50mm Square Axle 2000kg
- 1 x Pair 12" Off Road Electric Backing Plates + Park
- 1 x Pair of Weld rings on Axle
- 2 x 12" - 5 or 6 Stud Landcrusier Drums
- 2 X 9 Leaf Offroad Springs. 2000kg
- 1 x Spring Hanger Kit
- 2 x 2 tonne Bearings Sets
- 1 x 5/8" U Bolt Kit
- 1 x Voyager Brake Controller
- 1 x Treg Weld on Coupling.
- 1 x Park Brake Cable Kit
- 1 x Mechanical Park Brake
We use Offroad Electric braking plates with this kit because the Offroad magnets can handle the heat generated by offroad conditions better than standard magnets.
How to calculate Face to Face measurement on your axle. Measure the wheel offset. The offset is the distance between the inside of the hub on the rim and the outside of the rubber. Add 35mm- 50mm or the distance between the rubber and the chassis. Multiply by 2 for two side and then add your chassis width.
The disance between the face and the tip of the axle is 85mm.
Do not forget to leave your phone number at checkout. If your selections look missmatched, I will call you.
